Variable-Speed Pool Pump Rules in Florida
Last updated: November 10, 2026
Estimate your Florida pool cost
Federal rule (DOE, since July 19, 2021)
- Each dedicated-purpose pool pump that is not a submersible pump and is manufactured starting July 19, 2021 must have a WEF rating at or above the minimum in 10 CFR 431.465(f). The minimum depends on the pump type and its hydraulic horsepower.
- Integral cartridge-filter and sand-filter pool pumps made from that date must ship with a pool pump timer (431.465(g)).
- Pumps with freeze protection must ship with it disabled or with default settings no higher than 40°F, a 1-hour run time and half of maximum speed (431.465(h)).
- The rule covers pumps as manufactured. It sets a performance score, not a brand or motor name.
eCFR: 10 CFR 431.465. U.S. DOE: Dedicated-Purpose Pool Pumps.
Florida rule (s. 553.909 and the Florida Energy Code)
Florida Statutes s. 553.909(1) has the Florida Energy Efficiency Code set minimum requirements for residential pool pumps and pool water heaters, and s. 553.909(4) says residential pool filtration pumps and pump motors manufactured and sold on or after December 31, 2011 for installation in Florida must comply with it. Florida Statutes s. 553.909. Broward County's official 2023 Residential Energy Guidelines (a county checklist for the 8th Edition code) say residential pools must meet APSP-15, the Standard for Energy Efficiency for Residential Inground Swimming Pools and Spas, and list a minimum COP of 4 for heat pump pool heaters and 82 percent thermal efficiency for gas pool heaters. Broward County: 2023 Residential Energy Guidelines (PDF).
What APSP-15 asks of the pump (plain words)
- Pump motors may not be split-phase, shaded-pole or capacitor start–induction run types.
- Motors of 1 total horsepower or more must run at two or more speeds, with the low speed no more than half the maximum speed.
- Two-, multi- or variable-speed pumps must be installed with a controller that can run at least two speeds.
APSP-15 Florida language, Florida Building Commission consensus process (PDF). An earlier Florida code text, quoted by the Florida Building Commission in a declaratory statement, also set the controller's default to the filtration speed, with a high-speed override no longer than one normal cycle or 24 hours, whichever is less. Florida Building Commission: declaratory statement DCA03-DEC-128 analysis.
Florida's 9th Edition (2026) Building Code applies to permit submittals starting December 31, 2026, so section numbers may change. Hillsborough County: Residential & Mobile Home Checklists.
What it means for your project
- On a new pool permit, the pump is part of the plans. Cape Coral, for example, asks site-specific master pool permits for hydraulic calculations showing compliance with ANSI/APSP/ICC-15, plus a pump spec sheet with its pump curve. City of Cape Coral: Site-Specific Master Pool Permit documentation (PDF).
- Replacing existing pool equipment is licensed work in Florida; see CPC vs. CPO.
- For electricity cost math, see what does it cost to run a pool pump.
Questions
- Do I have to buy a variable-speed pump?
- The rules set performance and speed requirements instead of naming a product type. In Florida, a residential filter pump motor of 1 total horsepower or more must be able to run at two or more speeds under APSP-15. Ask your licensed contractor which models meet the rules for your pool.
- Does the federal rule make me replace a working pump?
- No. It applies to pumps manufactured starting July 19, 2021.
- When did Florida's rule start?
- The statute covers residential pool filtration pumps and motors manufactured and sold on or after December 31, 2011.
- Is this legal advice?
- No. It is a plain summary. Your building department and licensed contractor apply the code.
Get your Florida pool cost estimate