Fiberglass vs. Concrete vs. Vinyl Pool in Florida
Last updated: November 9, 2026
Estimate your Florida pool cost
Three construction types (plain words)
- Concrete / gunite / shotcrete: steel and sprayed or poured concrete shell finished with plaster or another interior; shape is flexible.
- Fiberglass: a factory-made shell set into an excavated hole and backfilled; the Florida Residential Code treats vinyl-liner and fiberglass pools as pools that are filled with water upon installation (2023 Florida Building Code, Residential, Chapter 45, Section R4501.19).
- Vinyl liner: a structural wall system with a replaceable vinyl membrane; the same code section notes vinyl-liner pools are filled upon installation; the hydrostatic-relief exception in R4501.21.4 applies to plastic-liner pools with no structural bottom (2023 Florida Building Code, Residential, Chapter 45).
Florida water table and uplift
In areas of anticipated water table, the Florida Residential Code requires an approved hydrostatic relief device, except for plastic-liner pools with no structural bottom (R4501.21.4). 2023 Florida Building Code, Residential, Chapter 45. An empty or partly emptied shell can be pushed by groundwater. That is a site and engineering issue for every permanent pool type; ask how dewatering and relief are handled on your lot.
Wind, flood and the permit
Pools in flood hazard areas must meet the residential flood provisions cited in Chapter 45 (R4501.4.2.1). Electrical bonding and GFCI rules for pool equipment are also in that chapter (R4501.16). Your city or county applies setbacks and lot coverage on top of the state code. City of Orlando Residential Swimming Pool and Spa Checklist is one local example of setbacks and equipment placement.
What drives cost (no new ranges)
- Excavation and haul-off.
- Dewatering if groundwater is high.
- Site access for a fiberglass shell delivery vs. on-site forming.
- Interior finish.
- Deck and screen enclosure (separate lines on this site).
- Engineering and permits.
Across the Florida permit offices we captured, the median declared value (the value on the permit, not a contract price) on new in-ground pool permits, filed or issued May 11, 2026 through November 11, 2026, was $70,000 (middle half, the typical range, $50,000–$98,000, 10,317 permits from 68 offices, checked November 2026). These are permit valuations: a floor, not a quote. Planning estimates, not quotes. We do not publish separate fiberglass or vinyl figures.
How to compare bids
Line up shell type, depths, finish, equipment, deck, cage, permits and exclusions in writing. See what a pool quote should include and what's included in a pool price.
Questions
- Which type is best for a high water table?
- Every permanent pool needs a groundwater plan. Florida's residential code requires hydrostatic relief where a water table is anticipated, with a stated exception for plastic-liner pools that have no structural bottom. Ask each bidder how they handle dewatering and uplift on your lot.
- Does this site price fiberglass and vinyl?
- No. Across the Florida permit offices we captured, the median declared value (the value on the permit, not a contract price) on new in-ground pool permits, filed or issued May 11, 2026 through November 11, 2026, was $70,000 (middle half, the typical range, $50,000–$98,000, 10,317 permits from 68 offices, checked November 2026). These are permit valuations: a floor, not a quote. We do not publish a separate fiberglass or vinyl figure. Planning estimates, not quotes.
- Do all three need a barrier?
- Yes. Florida's Residential Swimming Pool Safety Act applies to residential pools with water over 24 inches deep, including inground, aboveground and on-ground pools, hot tubs and nonportable spas. See Florida pool barrier law.
- Is this legal or engineering advice?
- No. It is a planning summary. Your building official and a licensed contractor or engineer apply the code to your site.
Get your Florida pool cost estimate